1. Blank garolite board (turret board)
2. Taped the layout to the board and used it as a drilling guide. Layout was drawn in a cad program at a 1:1 scale.
3. Drilling through the paper template into the garolite board with a 3/32" drill bit. This is the correct size for the turret to fit through. I used a speed square as a straight edge as a back stop to drill the holes nice and straight.
4. Holes drilled
5. Labeled the bottom of the turret board. I wanted to make sure I didnt put the turrets on the wrong side of the board.
5. To install the turrets I used a staking tool I got from Hoffman Amps. It consists of two bolts, one with a hole down the shaft to accept a turret and the other has a point on it to flare out the lug. The drill press was used as a light duty press. It was able to supply enough force to swage the turret
6. Top view of installed turret
7. Bottom view of installed turret
No comments:
Post a Comment